Accessories

ASG supply the following range of accessories. You can click on the item description to go direct to it, or simply scroll down the page to see the total range in sequence.

Index

Stainless Steel Fill Panel With Filling Whips
High Pressure Storage Banks
Automatic Condensate Drains
Nitrox Membrane System
Bauer Aero-Guard CO2 Removal System
Bauer Air Kool System
Bauer Seccant System
Bauer P-Filter System
Bauer Aero-Tester
B-Master Filling Station
B-Timer
B-Messenger

Brochures

Where available brochures can be downloaded for selected products via the link under the product photograph. These brochures are in pdf file format and require Adobe Acrobat Reader. Most modern browsers have a plug-in already built in to read pdf files. The file sizes vary, and downloads may take from 5 - 20 minutes depending on the file size and your modem speed.

Stainless Steel Fill Panel With Filling Whips

Panels can be custom made to suit your individual requirements. Panel supplied with pressure gauges, valves and ‘nipples’ and filling whips. Panel can be made to size, however to ensure enough room for gauges to accommodate two - three filling whips, the panel would need to be approx. 450mm wide by 450mm high by 150mm deep.

Back to Index

High Pressure Storage Banks

Heiser 50 ltr - 350 Bar Working Pressure Cylinders - (5000 PSI).
Weight: 85 kgs empty – 110 kgs full
Length: 170cms – from base of cylinder to top of valve
Diameter: 230cms
Price: P.O.A.

Back to Index

Automatic Condensate Drains

Automatic Condensate Drain systems allow for automatic drainage and discharge of oil and moisture from the compressor's intermediate and final separators. Build up of excess oil and moisture can reduce the filter life, reduce the compressor's output, and affect the quality of breathing air being produced by the compressor.

Scope of Supply consists of:
- condensate drain valves and solenoid valve;
- condensate separator with silencer
- timer, mounted in control box

Back to Index

Nitrox Membrane System

We are the Australian agent for a Nitrox Membrane system manufactured in the USA. This system is used extensively within the US diving shop market and the US Navy. ASG have installed many of these systems on live aboard and commercial diving vessels. Many dive shops throughout Australia also use this system.

The Nitrox membrane system essentially draws air, either from a low pressure bank that has previously been cleaned by a low pressure compressor, or from a HP storage bank. This air is then drawn into the Nitrox membrane. The Nitrox membrane outlet is connected to the inlet of the HP compressor, and the compressed Nitrox mix is then pumped (via the HP compressor) into stored HP banks, or directly into scuba tanks.

IT IS ESSENTIAL THAT YOU CONTACT YOUR COMPRESSOR MANUFACTURER TO ENSURE THEY WILL PROVIDE WARRANTY IF YOU USE YOUR COMPRESSOR FOR NITROX BLENDING

Membrane systems can be purchased as stand alone units that can be attached to the wall of dive shops, or to suitable areas within vessels.

When 'storing' Nitrox it is recommended to use stand alone HP banks. Additionally compressors must only run on the special oil provided by the supplier (ASG) of the Nitrox membrane system. Most Nitrox users buy stand-alone compressors that are only used for Nitrox mixing and filling.

Price: P.O.A

Back to Index

Bauer Aero-Guard CO2 Removal System

Download Brochure (pdf format)

AERO-GUARD reduces the CO2 content of breathing air far beyond the limiting values of the DIN EN 12021. Due to the constantly increasing CO2 -concentration in the air (due to unfavourable environmental influences), operators of filling stations find it more and more difficult to observe the limiting values for CO2 in a reliable way. With AERO-GUARD the operator is always on the safe side.

Back to Index

Bauer Air Kool System

Download Air Cooling Brochure (pdf format)

Through effective heat exchange, and a reduction in pressure dewpoint, the amount of moisture exposed to the filter cartridge is reduced by up to 80%.
This in turn can increase the filter cartridge life by as much as 600 per cent.

Back to Index

Bauer Seccant System

Download Air Drying Brochure (pdf format)

The Bauer Seccant system is a cost effective regeneration desiccator system that can be used to dry compressed air up to pressures of 350 Bar. The system has two pressure chambers, one is desiccating whilst the other is being regenerated through the process of desorption. Please contact ASG for more details.

Back to Index

Bauer P-Filter System

Download Bauer P-Filter System Brochure (pdf format)

The Bauer P-Filter System comprises of a 3 stage purification system. The first stage is a mechanical oil and water separator. This is followed by the adsorption of water and oil aerosols as the compressed air passes through a molecular sieve. The second stage consists of an activated carbon layer which removes oil vapours and odour. The third stage is a further molecular sieve layer and a particle filter. Please contact ASG for more details on the Bauer P-Filter System.

Back to Index

Bauer Aero-Tester

Download Brochure (pdf file)

The portable air test laboratory AEROTEST SIMULTAN HP enables you to carry out testing of the breathing air quality acc. to DIN 3188 and the new, more strict DIN EN 12021 standards.

The test tubes are an accurate system monitoring the values of oil mist, CO2, CO and water vapour in the compressed air. The equipment will allow up to four harmful substances to be measured simultaneously.

It is not necessary to calibrate the measuring device via a compressed air measuring tube before the testing procedure. The pressure reducer and special orifice plates guarantee a constant flow and continuous measuring facility.

Back to Index